Roller Type Sublimation Printing Machine
Features: 1.Top feed (three feeding two putting away, feed cloth, sublimation paper, interleaving paper , put away the used sublimation paper , and the used interleaving paper) 2.External automatic tank. 3.This machine is equipped with automatic income and feeding pieces of cloth automatically.....
Print this Page
Bookmark this
Inquiry product
E-mail UsFeatures:
1.Top feed (three feeding two putting away, feed cloth, sublimation paper, interleaving paper , put away the used sublimation paper , and the used interleaving paper)
2.External automatic tank.
3.This machine is equipped with automatic income and feeding pieces of cloth automatically function.
4.Air-pressing system, make sure good printing effect, the color more fresh .
5. double drum with full oil heating ,uniform heating, no chromatic aberration.
6.Adjust the woolen blanket automatically, conversion adjusting speed, external pressure regulation etc.
Product description:
1, This machine adopt the most advanced technology imported components, automatic spacing, accurate and reliable security, it can use long time.
2, The drum adopt the heating oil system, it can distribution the temperature more uniformity and stability.
3, It equipped with the unlimited adjust system, the feed equipment can be use convenient, safe, accurate security.
4, This machine has a rolling function, it is suitable for the roll fabric printing.
5, Get CE certificate, 1 year warranty.
|
Tems |
ROLLER HEAT TRANSFER PRINTING MACHINE |
Power Supply |
220V/50HZ (1phase ) |
|
Model |
MK-RTB |
Power |
7KW |
|
Roller Diameter(mm) |
200MM |
Heating Method |
Oil-based heating pipe |
|
Roller Width(mm) |
1200MM |
Tem.Range |
0-339C° |
|
Max. Felt Width(mm) |
1200mm |
Printing Speed(m/hour) |
100-120 |
|
Working Table Length(mm) |
1200MM |
N.W. |
430KG |
Operation of this machine :
1. Check that all screws in mainframe are loose or not, tighten if loose
2.The whole machine should be set at level with enough capacity; wood frame to overhead the sliding wheel and level direction is preferred
3.Keep the equipment in level while installation. Use level instrument to check if the machine is level or not.
4. When the working table is installed, the height must be consistent with feeding blanket and level. The paper feeding (put in) shaft and cloth feeding (put in) shaft must be of the same level with heating tank.
